Flight Control Configuration

  1. Setup Flight Controller Serial Port:

    • Telemetry-Port1 Setup:

      • Connect your flight controller to the PC via a USB cable.

      • Open Mission Planner and connect the flight controller to Mission Planner.

      • Navigate to the Full Parameter List and search for the following parameters (x = 0, 1, 2, 3 depending on the port used):

        • SERIALx_BAUD = 57 (which means 57600 baud rate).

        • SERIALx_PROTOCOL = 2 (which means MAVLink2 protocol).

        • The value of x depends on your telemetry port. If you are using Telemetry-Port1, set: - SERIAL1_BAUD = 57 (57600 baud rate). - SERIAL1_PROTOCOL = 2 (MAVLink2 protocol).

        • These values are for standard reference and should match the settings in the Airmesh flight control interface.

        • Note down the values of SERIALx_BAUD and SERIALx_PROTOCOL. Use these values in the Flight Control interface of Airmesh.

      • Write the parameters to the flight controller and perform a power reboot.

    • Power on the entire system and wait for the Airmesh Wi-Fi to become available.

  2. Connect to Airmesh Wi-Fi:

    • Ensure your PC or device connects to the Airmesh Wi-Fi network:

      • Wi-Fi Name: Airmesh

      • Password: Airmesh123

      • QR Code: Scan the QR code below to connect:

      Airmesh Wi-Fi QR Code

  3. Access the Flight Control Interface:

    • Open your web browser and navigate to the following IP address: - http://10.0.2.100:3000/

    • Click Flight Controllers on the left-hand side of the page.

    • The interface should appear as shown in the image below:

      Diagram showing the Airmesh flight control interface.

  4. Follow the Video Instructions:

    • Refer to the video tutorial below for detailed guidance on completing the setup: